Today's KNOWLEDGE Share:Molding at Constant pressure

Today's KNOWLEDGE Share

Historically, early injection molding machines would essentially be pressure controlled.Many good parts have been made under such process control. So, it is not all bad !

However, note that when molding an end-gated fairly long part, a constant pressure fill translates into an ever decreasing melt front velocity, as the pressure drop builds up.

This in turns corresponds to a decreasing average temperature of the melt front along the flow.

Such a decreasing T will create an increasingly strong degree of molecular orientation when moving away from the gate. The part, especially when using semi-crystalline grades, will have a strong gradient of mechanical properties along the flow which could be as serious as showing good ductility near the gate and severe brittleness far from the gate.

source:Vito leo